6008 z bearing belongs to deep groove ball bearing

6008 z bearing belongs to deep groove ball bearing, inner diameter D (mm) 40.
Deep groove ball bearing 6008 zinstallation: heating fit: by heating the bearing or bearing seat, the use of thermal expansion will be tight fit into loose fit installation method.It is a common and labor-saving installation method.This method is suitable for the installation of bearings with large interference amount. Before hot loading, put the rings of bearings or separable bearings into the oil tank for uniform heating of 80-100℃, and then take them out of the oil and install them on the shaft as soon as possible. In order to prevent the end face of inner ring and shaft shoulder from fitting tightly after cooling, axial fastening can be carried out again after cooling.

When the outer ring of the 6008 z bearing is tightly matched with the bearing seat made of light metal, the hot charging method of heating the 6008 z bearing seat is adopted to avoid the scratch on the matching surface.Heating tank with bearing and should be at a certain distance from the bottom of a mesh, or hanging hooks in the bearings, bearing on the bottom, in case of heavy impurities into the bearing or uneven heating, fuel tank must have a thermometer, strictly control the oil temperature shall not exceed 100 ℃, in order to prevent the tempering effect, reduce the hardness of the ring of 6008 z.

Cause of corrosion in folding for 6008 z bearing:
In many cases, 6008 z bearing corrosion will occur, there are many reasons for bearing corrosion, the most common in our daily life are the following factors.
1) Due to poor sealing device, it is invaded by water and dirt;
2) The bearing is not used for a long time, exceeding the rust prevention period, and lacks maintenance.
3) The metal surface roughness is large;
If you need 6008 z bearing or need any other bearings, please also contact me!
Contact: Leon
Email: nsk@zyslbearing.com
Skype: lh19881023
MP/Whatsapp: +8615098916271