One way locking ball bearing clutches introduction

One way locking ball bearing clutches, also known as one-way deep groove ball bearing, which can only transmit in a single direction; There are three main types of one-way clutches bearings:
1. Ball type clutches ;
2. Friction plate one-way clutch;
3. Spring type one-way clutch;
Among them, one way locking ball bearing clutches is the most common and mainly used in auto cars; Its working principle is that when the power source drives the passive component, only a single direction of transmission is available. If the power source changes direction (such as clockwise to counterclockwise), the transmission power of the passive component will stop.

In addition, the one way locking ball bearing clutches is stuck in both directions, which does not affect the performance at low speeds, while at high speeds, the power is insufficient because the guide wheel is still stuck; The one-way clutch slips in both directions, and at low speeds, it does not lock the guide wheel and therefore has no torque increasing effect, while at high speeds, the coupling connection is not affected in any way.

The one way locking ball bearing clutches uses GCr15 bearing steel, with a hardness of HRC61-65 after heat treatment. The bearing has a small volume and high load-bearing capacity, with sufficient space for storing lubricating grease and a longer interval for re lubrication.

The maintenance work of bearings is similar, for one way locking ball bearing clutches. as the relative motion between rolling elements and raceways and the invasion of pollutants and dust cause wear on the surfaces of rolling elements and raceways. Affects the accuracy of the host. The bearings used in silent machinery are usually maintained to prevent the invasion of pollutants and dust. Certain improvement techniques can be chosen to advance and achieve more satisfactory needs. Change the lubrication method, such as using oil and gas, oil mist, and spray lubrication; Improve cooling conditions, etc.