Installation and removal for rod end bearing home depot

Installation and removal for rod end bearing home depot:
1. Where the press is missing or cannot be used, the rod end bearing home depot can be installed with assembly sleeve and small hammer.The hammer force shall be evenly transmitted to the entire circumference of the end face of the end-bar articulated bearing ring, so the end face of the assembly sleeve shall be made into a ball.
2. The force required to install rod end bearing home depot is related to the size of the joint bearing and the size of the matching interference. For medium or large joint bearing with large interference, the heat loading method is commonly used.Before hot loading, put the end bar joint bearing or separable joint bearing ring into the oil tank or special heater and heat it evenly to 80-100℃, do not exceed 100℃.
3. Hot-mounted rod end bearing home depot need skilled operation skills.When the joint bearing is removed from the heating tank or heater, the oil mark and attachment on the surface of the joint bearing should be immediately wiped off with a clean cloth (note: cotton yarn is not allowed), and then placed in front of the matching surface, in one operation, the joint bearing is pushed to the place where the shaft shoulder is supported..When installing the end bar joint bearing, rotate the joint bearing slightly to avoid toppling or sticking.
4. When the outer ring of rod end bearing home depot and shell hole are in close coordination, the shell can also be heated and loaded into the joint bearing.In particular, the light metal materials of the joint bearing, in the process of tight fit, may cause damage to the surface due to its outer ring pressure, in this case, the rod end bearing home depot should be heated.
If you need rod end bearing home depot or need any other bearings, please also contact me!
Contact: Leon
Email: nsk@zyslbearing.com
Skype: lh19881023
MP/Whatsapp: +8615098916271